I was comparing the sizes of my source with the destination and noticed there were some discrepancies between them. I checked and the issue seems to be with SyncBackPro leaving the temp files behind without deleting them. The files are SBSE__XXX, after I delete all the SBSE files then the folders are the same size again.
I was initially worried there was a problem with the backing up process because of the size difference but it was just those residual files so it isn't a bit issue. I can easily find the files by searching SBSE and delete them. The annoying thing is the size of these files, varying from 100mb up to 4GB depending on the size of the files in the folder it is backing up. So I was wondering if there was something I could change so it checks for these files and deletes them on every run. This profile runs every day and doesn't copy over the SBSE files that are left over, so it knows they aren't proper files to copy so shouldn't it know to delete them?
I am using SyncBackPro v6.3.13.0 and am backing up a local drive to a network path.
I was initially worried there was a problem with the backing up process because of the size difference but it was just those residual files so it isn't a bit issue. I can easily find the files by searching SBSE and delete them. The annoying thing is the size of these files, varying from 100mb up to 4GB depending on the size of the files in the folder it is backing up. So I was wondering if there was something I could change so it checks for these files and deletes them on every run. This profile runs every day and doesn't copy over the SBSE files that are left over, so it knows they aren't proper files to copy so shouldn't it know to delete them?
I am using SyncBackPro v6.3.13.0 and am backing up a local drive to a network path.