Ok, I updated to the newest version, and I've also enabled Start With Windows. However, after doing so, I'm getting a UAC prompt every time I reboot the machine. We had discussed this issue in this thread:
viewtopic.php?f=15&t=10205
but the exact same issue is happening again. My working user is a regular user (in Users and Backup Operators groups), and the USB on-insert profile is created by the regular user.
I see the schedule in the task manager, where the SyncBackPro application is listed as Status:Ready and "At log on of machine\myuser". At the bottom it shows "Run only when user is logged on" is enabled, and "Run with highest privileges" is disabled.
I can't figure out why I'm getting a UAC prompt every time for this. (Thinking: Could it be because "Start with windows" in this case was enabled while SBPro had been opened as my regular user, and not the admin user? i.e. Does it matter if a program setting is enabled while the program is opened as an admin or as a standard user?) Is there any other way to trigger on-insert without having SBPro start with windows?
viewtopic.php?f=15&t=10205
but the exact same issue is happening again. My working user is a regular user (in Users and Backup Operators groups), and the USB on-insert profile is created by the regular user.
I see the schedule in the task manager, where the SyncBackPro application is listed as Status:Ready and "At log on of machine\myuser". At the bottom it shows "Run only when user is logged on" is enabled, and "Run with highest privileges" is disabled.
I can't figure out why I'm getting a UAC prompt every time for this. (Thinking: Could it be because "Start with windows" in this case was enabled while SBPro had been opened as my regular user, and not the admin user? i.e. Does it matter if a program setting is enabled while the program is opened as an admin or as a standard user?) Is there any other way to trigger on-insert without having SBPro start with windows?