Environment:
SyncBackPro V6.3.7.0 (30 Day Trial)
Copying from Windows 7 Pro (64bit NTFS)
Copying to Freenas 8 (ZFS)
Type of backup: SmartSync (so no compressing or encrypting)
Problem:
Basically, the Sync cancels/aborts or whatever around the 4GB mark. When I go look at the source machine where SyncBackPro is running, the program is no longer running. There is no log file for me to review, no final email was sent after which should occur after the job is completed. Also, I don't see any issues in the Windows event logs.
When I restart SyncBackPro and run the Sync job again, it picks up from where it left off and does another ~4GB until the program just exits or whatever again. This just feels like there is some timeout setting or something like that going on. Normally, 4GB makes me think of a FAT32 type of filesize limit, but I am syncing from an NTFS filesystem to a ZFS filesystem, so that shouldn't be an issue.
Any suggestions are welcome as I really need to get past this for any backups or syncs to complete.
SyncBackPro V6.3.7.0 (30 Day Trial)
Copying from Windows 7 Pro (64bit NTFS)
Copying to Freenas 8 (ZFS)
Type of backup: SmartSync (so no compressing or encrypting)
Problem:
Basically, the Sync cancels/aborts or whatever around the 4GB mark. When I go look at the source machine where SyncBackPro is running, the program is no longer running. There is no log file for me to review, no final email was sent after which should occur after the job is completed. Also, I don't see any issues in the Windows event logs.
When I restart SyncBackPro and run the Sync job again, it picks up from where it left off and does another ~4GB until the program just exits or whatever again. This just feels like there is some timeout setting or something like that going on. Normally, 4GB makes me think of a FAT32 type of filesize limit, but I am syncing from an NTFS filesystem to a ZFS filesystem, so that shouldn't be an issue.
Any suggestions are welcome as I really need to get past this for any backups or syncs to complete.