I created a new profile to back up project files. Here's the relevan info:
Type: fast backup
Destination M:\Bak\E\%DAYOFWEEK%\
On Fast Backup page:
Perform fast backup: On
Differential Backup: Off
Delete files and folders before backup: On
Full Backup Folder: M:\Bak\E\1\ (This is where I made a mistake, should have been 7)
Force rescan when %DAYOFWEEK% = 7
I'd hate to have to rerun the backup from scratch because it's taken 12 hours so far and isn't quite done yet. So my question is: once this initial first-time run is completed, can I change the folder on the USB drive from a 1 to a 7, and change the Full Backup Folder in SBPro to a 7 and just save the profile, to have it run future rescans on 7? Or do I have to change the settings and run the backup again now?
Type: fast backup
Destination M:\Bak\E\%DAYOFWEEK%\
On Fast Backup page:
Perform fast backup: On
Differential Backup: Off
Delete files and folders before backup: On
Full Backup Folder: M:\Bak\E\1\ (This is where I made a mistake, should have been 7)
Force rescan when %DAYOFWEEK% = 7
I'd hate to have to rerun the backup from scratch because it's taken 12 hours so far and isn't quite done yet. So my question is: once this initial first-time run is completed, can I change the folder on the USB drive from a 1 to a 7, and change the Full Backup Folder in SBPro to a 7 and just save the profile, to have it run future rescans on 7? Or do I have to change the settings and run the backup again now?